In the process of using the Wooden Floor PE Protective Film, the adhesive between the protected products is not strong, and it will fall off during transportation and use. The biggest possibility is that the protective film product is used in production. The viscosity of the pressure sensitive adhesive is not enough. There is also a possibility that the pressure of the molding machine used by the user when the mold is being applied is not enough, or the surface of the profile is not clean, dust or paint, etc., which affects the adhesive effect of the sensitive adhesive. ! If this problem occurs, it is necessary to aim at the cause, the right medicine, replace the sensitive glue to increase the film pressure, or pay attention to the effective cleaning of the surface of the profile when the film is applied to avoid such problems.
The Wooden Floor PE Protective Film performs well in the middle after a period of use, but the both ends are lifted up, so the main reason for such a phenomenon is that the protective film has a greater degree of stretching during the pasting process of the protected profile. After the post, in the high temperature environment, there is an unnecessary retraction phenomenon. This problem occurs mostly in the products of southern customers. Therefore, PE protective film should pay attention to the influence of environmental temperature difference on product use during the production process. Avoid unnecessary surface stretching during the pasting process.
When the wooden floor PE protective film is used, when the user tears off the protective film from the surface of the profile after the profile is installed, the adhesive of the protective film does not follow the protective film, but remains on the profile product. This is the user's least willing to see, because it is very troublesome, need someone to scrape the glue off the profile, especially time-consuming, there are many possibilities for this problem, you can use a clean rag to get a little alcohol Repeat the wiping of the residual sensitive adhesive until the sensitive adhesive is wiped clean.
Related Industry Knowledge
- PET material protection film
- Protective Film Classification by nature
- Electrostatic film
- Reticulated membrane
- Antistatic PET protective film
- Antistatic mode
- Selection of protective film
- Features of CPP protective film
- Development status of protective membrane
- Application of PE protective film
- Peeling effect and requirements of PE Protectiv...
- Unique advantages and product quality requireme...
- Good light transmission and moisture-proof requ...
- The manufacturing process and production situat...
- Industrial field and surface requirements for S...